오홈_'s post

A detailed look at the Woodball Multi-tap DIY process! The Ohai Home Wood Ball Multi-tap DIY set includes a multi-tap, a wood ball, and a power plug, and you only need to prepare scissors, a Phillips screwdriver, and nippers separately. ⚒️ 1. Cut the multi-tap plug part with scissors, and insert the wood ball in the combination you want. (Leave about 7 cm of wood ball from the end of the wire and finish it.) 2. Strip the wire covering slightly larger than a finger joint. 3. When you strip the covering, you will see 3 small wires. Remove 1.5 cm of covering from each of these wires. (Blue and brown are power wires, green is ground wire.) 4. Unscrew the power plug included in the set, and insert the copper wire into the 3 holes. Insert the blue and brown wires into the 2 holes on both sides, and the green wire into the middle hole. Tighten the screws again. 5. Completely assemble the power plug to complete the wood ball multi-tap~ Strip the wires and I was a little worried because there was a reassembly process, but it was easier and more fun than I thought :) It's the best desk interior item that adds practicality and emotion ✨